2008 Apr
NOTE: THIS STANDARD HAS BEEN SUPERSEDED. This document uses the service attributes and parameters that are defined in the MEF Technical Specification “Ethernet Services Attributes Phase 2” and applies them to create different Ethernet services.
NOTE: THIS STANDARD HAS BEEN SUPERSEDED.
This document uses the service attributes and parameters that are defined in the MEF Technical Specification “Ethernet Services Attributes Phase 2” and applies them to create different Ethernet services. This document defines three generic service constructs called Ethernet Service types and specifies their associated service attributes and parameters used to create Point-to-Point, Multipoint-to-Multipoint, and Rooted-Multipoint Ethernet services. This document also defines the requirements for several Ethernet services that use these generic Ethernet Service types. In addition, an informative appendix is provided showing examples of some of the defined services. This document supersedes and replaces MEF 6, Ethernet Services Definitions – Phase 1.
Standards published by MEF are intended for general distribution to the public and may be downloaded from this site and reproduced without charge. Any reproduction of MEF documents shall contain the following statement: “Reproduced with permission of MEF Forum.” All rights granted to MEF under applicable copyright laws are expressly reserved. No permission is granted to any recipient or user of MEF publications to modify any of the information contained therein and MEF disclaims all responsibility and liability for such modifications.